See the procedures needed to revive a dead computer
Its not something we like to think about but your computer will fail, if you keep it long enough.It may be a simple problem,such as the floppy drive not reading the disk to a major system crash.

Because computers are run by operators,User Error is the most common cause of computer malfunction.When the user is at the computer,he or she may add or delete certain files.Or he/she may remove or exchange certain hardware features.

When we look at user error,we must remember that since we're human,the user error may be easy to solve by simply asking the last user if he/she installed any software,re-configured any software or hardware settings,etc.

A large percentage of computer malfunctions are due to environmental factors such as power surges caused by lightning, resulting in overvoltage.

Another cause for failure may be room temperature being too high or low,as well as dust,dirt,or sunlight.

If you're in business and heavily dependent on your computers,such fators as room temperature,sunlight and protection against power surges is of the utmost importance and simply cannot be overlooked.

The most common pc problem is when you can't access your PC at all.When you turn on the power switch,and nothing happens,your computing will be put on hold.

Here is a quick checklist of troublshooting procedures you should follow if you encounter this problem . Download or view the short videos that show you how to perform these procedures:

Try the Power Switch a second or third time.If nothing happens..

** Check the wall outlet for power.If the outlet has power.

** Check the power cord itself from wall to computer. Copy and paste the below videos into your web browser to download. http://www.ultimatepcrepair.com/files/outlet.mpg

** Check the Power Supply inside the System Unit.

** Replace the Power Supply rather than trying to repair it. http://www.ultimatepcrepair.com/files/inspower.mpg

** If the system make those click noises,but the screen is blank, check the Monitor. http://www.ultimatepcrepair.com/files/mont.mpg

** If the monitor proves to be good,check the Video Card, even in a new system. http://www.ultimatepcrepair.com/files/vid4.mpg

Another big headache you will most likely encounter if you're a regular user of your computer system,is the fact that Windows will fail to load or the system's POST will fail to run.Preventive maintenance procedures that can be done to keep your PC running at peek performance.

Running such Windows ultilities as Scandisk,Disk Defragment,and Disk Cleanup will help your computer performing at its best.Using a can of compressed air removes dust that could build to the point of causing a short.

If you get the computer to boot but it does not want to read from the hard drive'the Master Boot Record on the hard drive may be corrupted or even missing. To verify that the master boot record has not been damaged...

Boot from the floppy disk that contains the FDISK program and type the command " fdisk mbr " to restore the master boot record onto your hard drive.

About the Author

Otis F. Cooper is solely dedicated to boosting the knowledge and confidence of every computer user that is serious about knowing computers.Use his informative articles and videos to understand every aspect about the PC.Read more about his formula for pc training at http://www.ultimatepcrepair.com